Snow Performance Gas Stage I The New Boost Cooler Forced Induction Water Injection Kit, SNO-201

The Snow Performance Stage 1 Boost Cooler® water-methanol injection kit is available for all forced induction applications (supercharged/turbocharged). Operation is simple and reliable: the system starts injecting when the boost switch reaches the user-adjustable point and injects a fixed amount of fluid through the nozzle until boost goes below the set switch point. Proven to deliver 30-70 HP increases to all forced induction applications!

This makes it a good choice for low to medium boost setups (1-15 PSI) looking for an octane enhancement and cooler intake charge. Activation can also be set up through any other user-chosen switch, such as a full throttle switch, nitrous switch, etc.

Kit Includes:

300 PSI UHO (Ultra High Output) Pump

3 Quart Reservoir

All Tubing Necessary for Installation

10′ Â Inch High Temp Nylon Tubing

18" High pressure Boost Line

3′ (Black) Wire Loom

Boost Switch (1-15 PSI)

Pig Tail Harness

Level Switch Upgrade

1 Nozzle Holder/Check Valve Combo

3 Hyper-Sonic¢Â„¢ Nozzles (175, 375, 625 ml/min) For Applications up to 1,000 HP (for custom nozzle selection give us a call at 719-633-3811)

Required Hardware Needed For Installation

Snow Performance Running S Decal

Comprehensive Instructions to Install on Any Forced Induction Vehicle

Snow Performance 1-Year Warranty

WARNING: This product can expose you to chemicals, which is known to the State of California to Cause Cancer, Birth Defects, And Other Reproductive Harm.